Description
Evercoat Optex 440 Light Speed UV Micro-Pinhole Eliminator 118ml
440 Express LIGHT SPEED™ a 1K UV LED Cured for micro-pinholes that are hard to identify prior to primer application.
This patent pending technology is a high-solids polyester that is easy to apply and cured in 30 seconds (i) leaving a ready to prime surface. Testing has shown, when used correctly, will eliminate up to 90% of all rework caused by micro-pinholes.
Ready to prime in just 30 seconds when cured with
UV LED Lamp (i)
Eliminates micro-pinholes
No sanding required
SHAKE WELL
Application
If excess material builds up on the repair area, lightly sand with P320 grit or finer after cured to remove any excess product prior to applying primer.
NOTE: Use UV-A LED Lamp rated at wavelength of 395nm and min. irradiance of 30 mW/cm2 for
proper cure
(i) All tests were conducted using a SCANGRIP® UV-GUN
IMPORTANT SAFETY INFORMATION. The use of equipment not recommended by the manufacturer or contrary to the instructions may cause an unsafe condition.
READ AND FOLLOW ALL SAFETY INSTRUCTIONS with UV/LED curing equipment manufacture
NOTES:
– When using waterborne primers, finish by preparing with a grey Nylon Web, then follow your waterborne coating manufacturer’s recommendation
– 440 Express LIGHT SPEED™ is not designed to replace polyester glazing putties, or recommended for use over conventional bodyfiller.
